The Piecing Process Makes Wood more Stable

Wood into furniture before to experience how many times the knife chopping, and even pulverized, both to retain the beauty of the wood, there to remove its "temper" due to the qualities of the wood itself, solid wood furniture will appear cracked deformation phenomenon. 

Before the wood becomes furniture, it has to go through how many times the knife and axe, and even pulverised, both to retain the beauty of the wood, there to remove its "temper" due to the characteristics of the wood itself, solid wood furniture will appear cracked deformation phenomenon. 

Primary timber processing is carried out in accordance with the dimensional requirements of the components of the product. Cutting is the cutting of the timber to the required size. The required dimensional width is cut according to the size requirements. This is an important part of the material selection process, as unqualified material will have a direct impact on the quality of the product and the result. The following high-frequency splicing equipment supplier will explain the specific requirements of the splicing process.

After the wood has been processed in length and width, it is then processed in thickness. This completes the first step in the preliminary selection process. Next, the timber is cut in multiple pieces by means of a multi-slice saw. To ensure that the panels are aesthetically pleasing, the colours and textures of each component are strictly compared to each other to ensure that the product is of high quality. 

In order to avoid this problem as far as possible, the timber needs attention during the "splicing" process, i.e. the whole board is cut into several strips and then spliced together, in order to eliminate the parts of the timber with defects and to reduce the coefficient of increase and contraction of the timber and improve its stability.

In order to create high-quality wooden products, the splicing process has strict requirements.

1. Consistent thickness

The planing and repairing of the wood is a basic requirement to ensure the quality of the panel, and must be done in strict accordance with the process indicators to ensure that the thickness of the veneer is consistent.

2. Consistent colour

The colour difference is the most intuitive factor leading to good or bad splicing, strictly select the veneer with the same colour and grain pattern for splicing; apply glue evenly to prevent gaps between veneers.

3. Orderly pressurisation

When using the splicing machine to splice the board, first add auxiliary pressure to flatten the board, and then add the lower pressure; dismantling first unload the lower pressure, and then unload the auxiliary pressure, to prevent the splicing board just pressed is not completely set and cracked.

High-frequency splicing equipment, using high-frequency splicing heating, two-dimensional pressure, can be used for splicing, wood strip edge sealing, L-shaped door set line combination, door core board splicing. It can solve the problems of heating speed, heating efficiency, automatic production and environmental protection and safety in the process of splicing boards in a more efficient way.